OPPapers.com Essay Index >> Technology >> Mcse Study Guide
We have many free term papers and essays on Mcse Study Guide. We also have a wide variety of research papers and book reports available to you for free. You can browse our collection of term papers or use our search engine.
MCSE Study Guide Installation The following are the installation requirements for a Windows 2000 Professional workstation: ? 133 MHz or higher Pentium-compatible
(Canada NewsWire, p.1). However, network administrators who obtain certifications "such as MCSE or CNE" will naturally be expected to earn higher wages than those
and learn as much as I can. I would like to take my degree from G.C.C and take it to Brockport to study Computer Science. I would like at least my bachelors in Computer
Submitted by trex1972 on February 21, 2006
Category: Technology
Words: 6456 | Pages: 26
Views: 380
Popularity Rank: 33,468
Average Member Grade: N/A (Add a Comment / Grade this Paper)
Installation
The following are the installation requirements for a Windows 2000 Professional workstation:
· 133 MHz or higher Pentium-compatible processor
· 64MB minimum; 4GB maximum)
· 2GB hard drive with a minimum of 650 MB of free space(Additional free hard disk space is required if you are installing over a network).
· Windows 2000 Professional supports up to 2 processors.
Always check the HCL before beginning any installation. Installations can be created on any type of partition-FAT, FAT32, or NTFS. NTFS is recommended, but use FAT or FAT 32 for dual booting. Upgrades can be performed on Windows 9x machines and NT 3.51 and higher OS's. To upgrade a Windows 3.1 or NT 3.5, first upgrade to Windows 9x or NT 4.0, respectively. To install over a network, install a distribution server first. Slipstreaming is the ability to install Windows 2000 and the service packs at the same time, and can be done using a distribution image for many computers. There are four logs for troubleshooting failed installations: Setupact.log, Setuperr.log, Setupapi.log and Setuplog.txt.
The following table lists some of the common switches available for use with WINNT.EXE
WINNT.EXE:
/e: command Executes a command before the last phase of setup.
/r: foldername Creates an additional folder in the folder where the Windows 2000 files are installed. The folder IS NOT DELETED after Setup finishes. You can use additional /r switches to install additional folders.
/rx: foldername Creates a folder to be copied as a part of setup - into the Windows 2000 directory, but the folder IS DELETED as setup finishes.
Use Winnt32.exe for a clean installation or upgrade from Windows 9.x or NT Workstation. There are a number of switches that can be used with winnt32.exe. Below are a couple of the important ones:
WINNT32.EXE:
/copydir: foldername Creates an additional folder in the...
You must Login to view the entire paper.
If you are not a member yet, Sign Up for free!